Corridor Carpet Runners for Stairs going up and down them make it more comfortable and also give more life to this sector of the house. A pad is located under the carpet, which is attached to the floor using strips without rivets. These strips protect the status of your staircase and can be removed without damaging if you want to modify it later. Subtract that measure the width of the corridor that you are installing. Assuming that the ladder is 75 cm wide and runner measures 65 cm, leaving 10 cm. Cut strips without rivets for each level that are 5 cm shorter than the width of the corridor, which is 24 60 cm in the example.
Place each strip into 2.5 cm of the marks you made earlier, which is 7.5 cm from the outer edges of the stairs. Place a strip against the back of the stage, in the part that walk, and at the bottom of the overhang or riser, the part that goes to each step, approximately 1.25 cm from where join the step and the cantilever. Cut the pad carpet the same width as the strips without rivets with knife carpet runners for stairs and leaves 5 cm to hang from the edge of each step. Staple each piece pad with a stapler.